1. Assembly design should try to avoid using some parts that need SMT machine pressure, such as wire pins, rivets, etc. In addition to slow installation, these parts may damage the circuit board, and their maintainability is also very low.
2. The number of components used on the board should be minimized. If two components have similar values but different tolerances, the one with the lower tolerance is preferred. The same screws should be used to fix the plates on all radiators, etc.
3. The use of latches to install smaller mounts and radiators should be avoided as this is slow and requires tools. Use bushing, plastic quick rivets, double-sided tropics or mechanical connections using solder joints.
4. Poor assembly design will directly affect the assembly and reliability.
