One： Host
1. Main power switch: turn on or off the power of the host
2. Visual display: display the recognition of images or components and marks obtained by moving the lens.
3. Operation display: display the Vios software screen of the machine operation. If there is an error or problem during the operation, the correction information will also be displayed on this screen.
4. Warning light: indicates the operating conditions of the mounter in green, yellow and red.
Green: the machine is in automatic operation
Yellow: error (return to origin cannot be executed, pick up error, identify fault, etc.) or interlock.
Red: the machine is in the emergency stop state (when the machine or ypu stop button is pressed).
5. Emergency stop button: press this button to trigger an emergency stop immediately.
Two： Working head assembly
1. Working head assembly: move in XY direction (or X direction), pick parts from feeder and mount them on PCB.
2. Moving handle of working head assembly: when the servo control is released, you can move in each direction by hand. This handle is usually used when moving the working head assembly by hand.
Three ：Visual system
1. Moving lens: used to identify the mark on PCB or to track the position or coordinates.
2. Independent visual lens: used to identify components, mainly those with pins QPF
3. Backlight unit: when identified by independent visual lens, irradiate the element from the back.
4. Laser parts: the laser beam can be used to identify parts, mainly sheet parts.
5. Multi video lens: it can recognize many kinds of parts at one time and speed up the recognition speed.
Four： Feeding platform
Belt feeder, bulk feeder and tube feeder (multi tube feeder) can be installed on the front or rear feeding platform of the placement machine.
Five： Shaft structure
X axis: the moving head assembly is parallel to the PCB transmission direction.
Y axis: the moving head assembly is perpendicular to the PCB transmission direction.
Z axis: control the height of the working head assembly.
R axis: control the rotation of the suction nozzle axis of the working head assembly.
W axis: adjust the width of the transport rail.
Six： Transport rail components
1. Main baffle
2. Positioning pin
3. Push in part
4. Edge clamp
5. Push up the plate
6. Push up the thimble
7. Inlet baffle
Seven： Suction nozzle station: automatic exchange of suction nozzles is allowed. It can load 16 suction nozzles, 7 standard suction nozzles and 9 optional suction nozzles.
Eight： Air source components: including air filter, air pressure regulating button and barometer.
Nine：Input and operating unit
1. Ypu programming unit
Ready button: release of abnormal stop and action of servo system.
2. Keyboard