Various key factors have to be kept in mind while designing a PCB for a quality design. An important principle of PCB design, which becomes more critical in mixed signal design in order to avoid noisy signals and abnormal functioning is keeping analogue and digital grounds separated. Since in auto-routing the computer recognizes it as a single ground and routes accordingly, grounds are to be routed manually to avoid it. In addition to this:
For each digital IC, capacitors should be placed between its input power and ground
High frequency tracks should be kept short
Signals with high frequency should have a ground plane below them; they shouldn’t be run over gaps
Analogue circuits and digitals circuits should be kept separated
Analogue ground and digital grounds should be kept separated but connected to a common point
90o bends in tracks should be avoided, instead 45o bends can be used to avoid noise and signal reflections.
Power and ground tracks should be wide so that they have a higher current limit, also they should be placed first
Auto-routing should be avoided when possible
There shouldn’t be any copper fills unconnected on a PCB. They can be grounded to act as a heat sink or removed.
Vias shouldn’t be placed under the components
Through hole components ca be used as vias since the hole is connected to layers underneath
Drill size for holes and vias should be kept minimum
NeoDen provide a full smt assembly line solutions, including SMT reflow oven, wave soldering machine, pick and place machine, solder paste printer, PCB loader, PCB unloader, chip mounter, SMT AOI machine, SMT SPI machine, SMT X-Ray machine, SMT assembly line equipment, PCB production Equipment smt spare parts etc any kind SMT machines you may need, please contact us for more information:
Hangzhou NeoDen Technology Co.,Ltd
Web: www.neodentech.com
Email: info@neodentech.com
