+86-571-85858685

Analysis Of Copper Laying In PCB

Nov 04, 2020

I. Reasons for copper laying:
1.EMC plays a shielding role for copper covering a large area of ground or power supply. In some special cases, such as PGND, it plays a protective role.
2. PCB process requirements. Generally, copper is laid on PCB with less wiring in order to ensure plating effect or lamination without deformation.
3. Signal integrity requirement: give a complete backflow path to high-frequency digital signals and reduce dc network wiring. Of course, there are heat dissipation, special device installation requirements copper, and so on.


II. Advantages of copper laying:
Laying copper big benefit is to reduce ground impedance (there was a large part of the so-called anti-jamming is to reduce ground impedance) of the digital circuit exists in a large number of peak pulse current, thereby reducing ground impedance is more necessary to some, is generally believed that for the whole circuit composed of digital devices should be large floor, for the analog circuit, formed by laying copper ground wire loop will cause electromagnetic coupling interference hampered (high frequency circuit. Therefore, not all circuits need to be copper. (BTW: network copper paving is better than whole paving.)


III. The significance of copper laying lies in:
1. Lay copper and connect the ground wire, which can reduce the loop area.
2. Spread a large area of copper equivalent to reduce the ground resistance, reduced the pressure drop in these two points, both figures, or simulation should be laying copper in order to increase the ability of anti-interference, and at the time of high frequency should also spread their digital and analog ground to separate copper, then they are connected by a single point, the single point of wires can be used on a magnetic ring around a few laps, and then linked together. However, if the frequency is not too high, or the working conditions of the instrument is not bad, it can be relatively relaxed. The crystal oscillator ACTS as a high frequency emitter in the circuit. You can lay copper around it and then ground the crystal oscillator shell, which is better.


NeoDen provides a full SMT assembly line solutions, including SMT reflow oven, wave soldering machine, pick and place machine, solder paste printer, Reflow oven, PCB loader, PCB unloader, chip mounter, SMT AOI machine, SMT SPI machine, SMT X-Ray machine, SMT assembly line equipment, PCB production Equipment SMT spare parts, etc any kind SMT machines you may need, please contact us for more information:

Hangzhou NeoDen Technology Co., Ltd

Web: www.neodensmt.com

Email: info@neodentech.com

Send Inquiry