1. When installing component materials, the tearing belt is too long, and too much pressing material causes unnecessary material loss and loss;
Solution: Train the operator to keep two or three empty Spaces when loading, press the material to the material window to see the material, so that the position of SMT Feeder gear and the tension of the coil can be checked.
2. There are sundries on the TABLE after the installation of SMD Feeder, which causes the inposition and can not get the material by shaking;
Solution: Train the operator to check whether there are sundries in the machine TABLE and Feeder base when loading Feeder, and clean the machine TABLE when rotating.
3. The material tray is not properly installed on the Feeder, resulting in the chuck, Feeder Tape floating high casting;
Solution: Strictly require the operator to put the tray on the Feeder when refueling.
4. Tension change, no TAPE winding, poor feeding and Feeder TAPE floating high casting problem caused by not clearing the coil in time;
Solution: Strictly require operators to clean the coil when refueling.
5. Loss caused by putting the wrong plate, jumping the wrong plate, rubbing the plate, etc.;
Solution: Operators are strictly required to operate according to the operation instructions, and mark the position of the assembly board, the direction of plate entry and matters needing attention in the instructions.
6. The wrong material station, P/N caused by the wrong material;
Solution: Train the operator to check the material P/N and machine alarm display, discharge table station position.
