with the evolution of the times, technological progress, environmental protection requirements, the electronics industry also with the times of the wheel active or forced to move forward, the technology of the circuit board is not so. Here are several circuit board surface treatment is currently more common process, I can only say that there is no perfect surface treatment, so there are so many choices, each surface treatment has its own advantages and disadvantages, the following interview to list.
Advantages:
low cost, flat surface, good solderability (in the case of no oxidation yet).
Disadvantages:
easy to be affected by acid and humidity, can not be stored for a long time, after unpacking need to be used up within 2 hours, because the copper is exposed to the air easily oxidized; can not be used for double-sided process, because after the first reflow the second side has been oxidized. If there are test points, solder paste must be added to prevent oxidation, otherwise the subsequent contact with the probe will not be good.
Advantages:
can get a better Wetting effect, because the coating itself is tin, the price is also lower, good soldering performance.
Disadvantages:
Not suitable for soldering fine gap feet and too small parts, because the surface flatness of the spray tin plate is poor. In the PCB process is easy to produce tin beads (solder bead), the fine pitch (fine pitch) parts easier to cause a short circuit. When used in the double-sided SMT process, because the second side has been the first high-temperature reflow soldering, it is very easy to melt the spray tin again and produce tin beads or similar water droplets by gravity into drops of spherical tin spots, resulting in a more uneven surface and thus affect the soldering problem.
Advantages:
not easy to oxidize, can be stored for a long time, the surface is flat, suitable for soldering fine gap feet and solder joints of smaller parts. Preferred for circuit boards with key lines (such as cell phone boards). Can be repeatedly reflowed many times is not likely to reduce its solderability. It can be used as a substrate for COB (Chip On Board).
Disadvantages:
Higher cost, poorer solder strength, easy to have black pad/black lead problem because of using electroless nickel process. The nickel layer will oxidize over time, and long-term reliability is a problem.
Advantages:
Has all the advantages of soldering bare copper boards, and expired (three months) boards can be re-surfaced, but usually in one pass.
Disadvantages:
Easily affected by acid and humidity. When used in secondary reflow, it needs to be completed within a certain time, and usually the second reflow will be less effective. If stored for more than three months, it must be re-surfaced. OSP is an insulating layer, so the test point must be printed with solder paste to remove the original OSP layer in order to contact the pin point for electrical testing.

